KG F74

KG-F74 Thermoforming Machine

THERMOFORMING
Forming Area 710 x 480
Max. cutting dimension (mm) 690 x 450
Max. positive depth (mm) 10 max
Max. negative depth (mm) 150
Max. sheet width (mm) 750
Clamping force (kN) 250
Upper heating, installed power (Kw) 83 (full opt)
Lower heating, installed power (Kw) 66 (full opt)
Dry cycles speed (cicles/1’) 33
Processing air pressure (bar) 8
UNWINDER
Reel holder Single
Max. reel diameter (mm) 1200
GENERAL FEATURES
Total installed power (full opt – Kw) 190
Lenght (mm) 11.300
Width (mm) 3.500
Height (mm) 3.400
Weight (stacker excluded – Kg) 12.100

General Features

– Synchronized forming and cutting by tilting movable lower platen to 85 degrees
– Sheet ; pitched by double toothed chains and move on abrasion resistant slide plates;
– Precise heater control for upper and lower pan.
– Upper and lower Mold ; heats control by indivudial Thermoregulation device
– Fine adjustment for mold by electric drive.
– PLC for control the line operation and to supervise working parameters
– Non-stop working capacity with easy maintain mechanical system.
– Safety system ensured by sensors  such as sheet  sagging , pressure drop,door ajar situations
– Water and Heat balance measure sensors for mold  which can be control by PLC system
– Energy analyzer which gives amount of the electric consumption
– Cutting adjustment possible by digital meter ,controlled by PLC.
– Plug asist motor and plug speeds all controlling by PLC suitable to put variotions of movement to plugs to plugs,start slow go fast end slow etc